新闻中心
Book binding, ordinary paper box sealing, selection Hot melt adhesive granules The EVA products inside are basically sufficient; When encountering difficult to stick plastics such as PP and PE, or packaging that requires low temperature/aging resistance, consider PO (polyolefin) type. The two are not better, but have different applicability.
| Dimension | EVA hot melt adhesive granules | PO hot melt adhesive granules |
|---|---|---|
| Common substrates | Paper, cardboard, fabric, and some PVC | PP、PE、 Non woven fabric, difficult to stick plastic |
| Initial adhesion speed | Quick, suitable for high-speed lines | Slightly slower, it needs to be pressed and shaped |
| heat resistance | Generally (softened at around 60 ℃) | Better, not brittle at low temperatures |
| Odor/Environmental Protection | Depending on the brand | Low odor and low VOC make it easier to produce |
| Price | more economical | relatively high |
Take the sample you actually want to stick as a sample: pull it open at room temperature to see the damaged surface. If the substrate is torn, it indicates that the strength is sufficient; If the adhesive layer falls off completely, it indicates that the wrong type or temperature has been selected. Sunlife hot melt adhesive has EVA and PO solutions for both book and packaging production lines. Guangzhou Sunlife Trading can send samples and test adhesives according to your substrate to avoid blind ordering.
Q1: Can PO completely replace EVA?
Cost wise, EVA is more economical for ordinary paper.
Q2: How to quickly distinguish which type is in your hand?
Check the “matrix resin” item in the test report, or send it to a third party for FTIR infrared identification.
Q3: Is there a problem with mixing two types of glue?
It is not recommended to mix and melt, as poor compatibility can lead to delamination and decreased strength.
Direct answer: It is recommended to choose multi-layer paper bags with high initial adhesion, medium to short opening time, and good folding resistance for sealingHot melt adhesive granulesThe softening point is above 90 ℃, commonly known as EVA high viscosity or APAO type. The difficulty of multi-layer paper bags lies in the multiple layers of […]
In the fields of book binding, brochure production, notebook production, etc., flat hot melt adhesive is the core bonding material, and the core demand is concentrated in180 ° flat spread without cracking, resistant to high and low temperatures, firmly bonded, affordable priceThere are numerous printing and packaging enterprises in Guangzhou and its surrounding areas, and […]
Conclusion Coking in a melt glue pot is the result of prolonged exposure to high temperatures and oxidation and carbonization of the adhesive liquid in contact with air. Cleaning is divided into four steps: “cooling and emptying – physical scraping – solvent wiping – reset”. Usually, temperature control, covering, and regular glue replacement are used […]
Direct answer:Hot melt adhesive pelletsThe residual glue cannot be washed with water or ordinary alcohol. Commonly used are specialized hot melt adhesive cleaning agents (glue cleaning agents), high flash point white oil/mineral oil, and citrus terpene cleaning agents used in small quantities. The principle is to ‘soften with oil while hot, mechanically remove after cooling’, […]
