新闻中心
The importance of product packaging is twofold: it helps maintain the safety and reliability of the contents and provides consumers with attractive products. The packaging process is one of the most important stages in product manufacturing and distribution. With decades of experience as a packaging hot melt adhesive manufacturer, Sunlife Hot Melt Adhesive is delighted to have the opportunity to share its professional knowledge with customers.
In the flexible packaging industry, speed is of paramount importance, and hot melt adhesive is the preferred technology. However, high production speed sometimes introduces a potential side effect called pulling. When the extruded packaging hot melt adhesive is not completely separated from the nozzle tip, wire drawing occurs, which can cause fine hot melt adhesive strands to interfere with the sealing process of the assembly line. These filaments can be stacked on application devices and present the appearance of ribbons or angel hair as described by the user.
The main reason for pulling wires is:
The application temperature of the extrusion tip is too low. The adhesive is too thick. The application tip is too far away from the surface of the substrate.A simple adjustment is to slightly increase the temperature of the hose and nozzle – by 5 ° C each time. The next adjustment is to bring the tip of the nozzle closer to the surface of the target substrate. If possible, adjust the solenoid valve pressure at the tip of the applicator, but if this is not helpful, clean or replace the nozzle to clean the cut-off. Finally, it is recommended to install the fan or
The airflow of HVAC circulation is redirected away from the application area.
Eliminating wires will reduce downtime, defect count, and avoidable waste during cleaning. This can be achieved by selecting suitable hot melt adhesives for the packaging industry, optimizing application equipment settings, and controlling the workplace environment.
Direct answer: The most secure arrangement for sealing and gluing points is to leave 20-30mm at both ends, evenly distribute in the middle, and cover a total length of about 60% -70% of the sealing length. The common three-point, five point, and strip continuous methods have their own applicable scenarios. Choosing the wrong arrangement not […]
First answer: Having more fine powder does not necessarily mean poor quality, but it is worth asking a question Hot melt adhesive granulesA small amount of fine powder at the bottom of the bag is a normal phenomenon. Particles rub against each other during granulation, cutting, conveying, bagging, and long-distance transportation, inevitably producing powder. The […]
Bookbinding adhesive is a flexible and durable hot melt adhesive used in bookbinding. This combination creates a book that can withstand bending and folding without spine cracking or page pulling. Hot melt adhesive for books and periodicals is divided into book edge adhesive and book back adhesive according to their uses. EVA hot melt adhesive […]
Under standardized storage, the shelf life of EVA hot melt adhesive granules is usually 12-24 months; Polyolefin and other systems can last longer. But ‘shelf life’ does not mean ‘just leave it at will’, the environment determines the actual usable time. Key factors affecting shelf life Reference for shelf life of different systems system Reference […]