新闻中心
Choose hot melt adhesive granules and focus on 7 key parameters: softening point, melt viscosity, opening time, curing time, initial adhesion, temperature resistance range, color and appearance. This article compiles the meanings, common ranges, and selection points of each parameter into a table, which can be directly compared and used by procurement and technology.
| parameter | Common intervals | Key selection points |
|---|---|---|
| softening point | 75-110℃ | Determine heat resistance, it is recommended for summer warehousing logistics to be above 85 ℃ |
| Melt viscosity | 1000-8000mPa·s(180℃) | Choose low viscosity and good flow for high-speed lines, and high viscosity for thick adhesive layers |
| Opening hours | 5-60 seconds | Match the rhythm of the equipment, the glue binding line should be short and the mounting should be long |
| curing time | 2-15 seconds | Determine the length of the pressing station, fast line with fast curing |
| Initial tack | Measured by peel strength | Sealing and pasting boxes require high initial adhesion and anti rebound |
| Temperature resistance range | -From 20 ℃ to 70 ℃ | Select based on extreme temperature during storage and transportation |
| Color Appearance | Water white/light yellow/yellow | Books and periodicals should be selected with white water that does not penetrate the bottom, and light yellow can be used for sealing |
Q: Where can I get the parameter table?
Regular manufacturers have technical parameter tables for each model, and Sunlife hot melt adhesive can provide TDS with samples, including recommended construction temperature and all key parameters.
Q: How to choose between two models with similar parameters?
Prioritize choosing the one with better actual testing results compared to your own materials. Guangzhou Sunlife Trading supports sending materials for testing, speaking with data.
Stick this table next to the procurement station and check the parameters item by item. The probability of selecting the wrong adhesive particles will be significantly reduced.
Chromium powder belongs to industrial chemical raw materials, and procurement decisions cannot rely solely on product names or quotations. Different purposes have different focuses on brand, technical data, packaging, batch identification, and on-site management. This article focuses on the connection between procurement and use, explaining how enterprises should communicate their needs during inquiry, trial, acceptance, […]
Direct answer: For paper bag rope adhesion, hot melt adhesive particles with high initial adhesion, good flexibility, and a softening point of 75-85 ℃ should be used. The diameter of the adhesive point should be 8-12mm, with one point at each rope hole. Press and hold for 3-5 seconds.The key is not in the amount […]
Recycled kraft paper boxLow surface energy, high dust content, and easier detachment after moisture absorptionDirectly applying the sealing glue of the original cardboard box often opens the glue. The conclusion is:The regeneration box should be selected with “high initial adhesion, moisture resistance, and moderate penetration” sealing special rubber particlesAnd perform surface treatment before applying glue. […]
temperature change of hot melt adhesive hot melt adhesive is a thermoplastic material – or polymer – that usually becomes flexible at warm temperatures. On the contrary, during the cooling process, the hot melt adhesive solidifies and eventually forms a well-known long-lasting bond. Temperature and its variation patterns have a significant impact on the performance […]
