新闻中心
How to reduce the drawing problem of packaging hot melt adhesive? The manufacturer’s downtime may come at a high cost. Preventing production issues and maintaining production line operation are crucial for brand owners. Threading is a common issue that affects consumer packaging. Reduce the drawing of hot melt packaging adhesive by making some easy to implement changes to three variables (equipment, environment, and adhesive).

Equipment: Check the settings every time the production line is changed
1. Check the position, angle, temperature, nozzle size, and condition
2. Confirm that the nozzle head is not blocked and in good condition
3. Check the distance between the nozzle and the substrate to determine if it can be reduced
4. Check the filter and hose to confirm that there is no accumulation or carbonization
5. Check the solenoid valve and fuel tank pressure
Environment: Environmental temperature and airflow can impactPackaging hot melt adhesive
1. Reduce direct airflow to avoid high viscosity and premature adhesive drying
2. Review the airflow in the production area to ensure that the fans and; HVAC The system will not directly blow towards the application point. This is more critical in applications where the distance between the nozzle and the package is large.
3. Substrate temperature is also a factor
Adhesive: Specific operating parameters are set by the formula
1. Check if the temperature of the hot melt tank is correct. If the hot melt adhesive is too sticky, the temperature may be too low
2. If the applicator and hose are not hot enough, please confirm to set the applicator temperature according to the recommended operating instructions, and then the adhesive will start to cool when moving from the can to the applicator
3. Confirm with the adhesive supplier that the correct adhesive has been used in the application. Some adhesives are easier to draw than others.
What are the ways to change the demand for packaging hot melt adhesive? Decades ago, primary packaging was the main focus of manufacturers, shop owners, and consumers. In most cases, few people handle the goods before they enter the hands of shop owners and consumers. However, once the hypermarkets began to take effect, increasing the […]
Although EVA hot melt adhesive is an excellent solution for many industrial applications, it requires careful control of the high temperature during the process to avoid smoke problems. When hot melt adhesives are heated, they inevitably release some smoke. That is the odor detected while working near the hot melt nozzle. Although some smoke is […]
Why is it harder to bond aluminum foil coated paper than regular paper? Aluminum foil coated paper has a layer of metal film on its surface, which is dense, smooth, and has low surface energy,Hot melt adhesive granulesIt is difficult to wet after coating, and the initial adhesion is much lower than that of copperplate […]
In the wireless adhesive packaging process of books, the uneven thickness of the adhesive wire is a quality problem frequently encountered by printing factories and graphic and text fast printing factories. One side of the adhesive layer is too thick and overflowing, while the other side is too thin and debonding. This not only makes […]