新闻中心
Regarding the viscosity and stickiness of hot melt adhesive, many customers will always ask if your hot melt adhesive is strongly adhesive, which means “sticky”. Without specifying what material to stick, it is not possible to directly determine whether the hot melt adhesive is strong or not. Hot melt adhesive is only suitable or not, and there is no strong or weak viscosity, which is a misconception among many customers in consultation.

Viscosity is the internal friction of a fluid, which is the resistance to relative motion between one layer of fluid and another, i.e. the resistance to liquid flow. It is also an important parameter of hot melt adhesive, viscosity, also known as viscosity, refers to the degree of thinness of hot melt adhesive in its melted state. The lower the viscosity, the better the flowability of hot melt adhesive, the easier it is to produce glue, and the less wire drawing. Therefore, the viscosity is related to the coating, wetting, permeability, and wire drawing phenomenon of the adhesive. When it is clear which specific material to stick to, it is necessary to choose the appropriate viscosity based on the material to be glued and the shape, in order to produce a good bonding effect. As a professional hot melt adhesive manufacturer, Sunlife Hot Melt Adhesive only recommends suitable hot melt adhesives. The more expensive the hot melt adhesive, the better. Suitable hot melt adhesives are the best.
Pearl cotton, also known as EPE, is a foamed polyethylene polymer. Pearl cotton has many advantages such as water and moisture resistance, shock resistance, sound insulation, thermal insulation, good plasticity, strong toughness, recycling, environmental protection, strong impact resistance, and good chemical resistance. Features: low density, good flexibility, high recovery rate; Better shock resistance than polystyrene […]
The use of hot melt adhesive requires appropriate preparation and preheating to ensure smooth operation. 1. Glue Add an appropriate amount according to the amount of glue used and the size of the hot melt glue pool. During normal use, maintain a liquid level range of 35% -80% in the sol tank. If the amount […]
What are the difficulties in bonding velvet fabrics? The surface of velvet (corduroy, velvet, short hair velvet, etc.) is covered with fine fluff,hot melt adhesive pelletsAfter coating, it is easy to penetrate into the gaps of the fluff instead of sticking to the base fabric, resulting in low initial adhesion and easy detachment upon light […]
EVA hot melt adhesive is currently one of the widely used industrial adhesives. They are essentially thermoplastic based on polymers, which means they are solid at room temperature but liquefy when exposed to a heat source. In this article, you will learn more about hot melt adhesive: EVA hot melt adhesive. What issues should be […]