新闻中心
Recycled kraft paper boxLow surface energy, high dust content, and easier detachment after moisture absorptionDirectly applying the sealing glue of the original cardboard box often opens the glue. The conclusion is:The regeneration box should be selected with “high initial adhesion, moisture resistance, and moderate penetration” sealing special rubber particlesAnd perform surface treatment before applying glue.
| Comparison item | Original cowhide cardboard box | Recycled kraft paper box |
|---|---|---|
| surface energy | High, easy to wet | Low, prone to virtual adhesion |
| dust | few | Too many, hindering adhesion |
| moisture absorption | middle | High, moisture induced delamination |
| Glue requirements | Universal sealing adhesive | High initial adhesion+moisture resistance |
Sunlife hot melt adhesive for recycling box customers: ① Before sealing the boxBlow off the dust at the box mouth② AppropriateIncrease the glue application by 10-15%③ Press and hold for 2 seconds. Often, even without changing the glue, the opening rate can be suppressed. Guangzhou Sunlife Trading can send samples for actual testing according to your recycling box ratio.
Q1: Can the regeneration box be replaced with tape?
Sure, but the tape is also easy to peel off at low temperatures and high humidity, and hot melt high initial adhesive has better production line speed.
Q2: How to determine if it is a problem with the box?
The reason why the original box cannot be opened and the regeneration box cannot be opened when replacing the same batch of rubber is basically due to the surface energy problem of the regeneration box.
Direct answer: High fluidity hot melt adhesive particles are suitable for high-speed production lines, fine nozzle dispensing, thin paper/porous substrate penetration, and large-area pasting; For scenarios such as thick book back adhesive, vertical surface bonding, and heavy load bearing, conventional or high viscosity models are more suitable.There is no superiority or inferiority in liquidity, only […]
hot melt adhesive cost If you wish to switch to hot melt adhesive to meet the application requirements of your enterprise, then you are on the right track to reduce packaging costs. However, if you are currently using outdated manual adhesive alternatives for your business, such as tape or staples, then leveraging a hot-melt system […]
Most consumers interact with cardboard packaging almost every day, but they are not aware of this. This special multi-functional packaging can bring you food and beverages, household items, and many other items you frequently use. However, without a specific type of hot melt adhesive, this crucial packaging category cannot be achieved. This hot melt adhesive, […]
Hot melt adhesive granulesIt belongs to the production process mainly based on thermoplastic resin blending granulation, usually according toEnvironmental Impact Registration Form or Report FormCategory processing (subject to the list approved by the local ecological environment department), accompanied by pollutant discharge registration/permit, hazardous waste (such as waste filter cartridges, waste packaging) compliance disposal agreement, and […]
