新闻中心
The first few books and cardboard boxes couldn’t stick firmly when turned on, but then it became normal – this is almostHot melt adhesive granulesThe most common phenomenon in use. The root cause is usually that the temperature displayed on the glue cylinder has reached, but the glue has not yet fully penetrated, or there are still old glue cold sections left in the pipeline or nozzle from the previous time. Misunderstanding glue as having problems and repeatedly changing materials often results in wasted money.

| Steps | key points |
|---|---|
| 1. Preheat in advance | Power on 20 minutes earlier than working hours |
| 2. Constant temperature standing | After reaching the temperature, wait for 10-15 minutes for the glue to heat up completely |
| 3 rows of old adhesive | Empty 3-5 times, remove the degraded old glue completely |
| 4. Test the first piece | Conduct a test pull, and if it meets the requirements, proceed with mass production |
| 5 small amounts of frequent addition | Feed in batches to maintain stable cylinder temperature |
Sunlife hot melt adhesive comes with a brand and process card, indicating the recommended adhesive temperature and preheating time; Guangzhou Sunlife Trading can also assist in organizing the startup process into workshop dashboards to reduce the pitfalls of shift handover.
If there is a downtime of more than one hour during lunch break or shift handover, it should also be treated with “constant temperature and glue discharge” when starting again, and cannot be directly continued. It is recommended to use up or drain the remaining glue in the rubber cylinder as much as possible before the long holiday shutdown, to avoid long-term high-temperature insulation that may cause the entire cylinder to degrade and coke. Starting up after the holiday is both time-consuming and prone to clogging. A signboard next to the equipment indicating the preheating time and the number of adhesive discharges is much more reliable than verbal handover.
Q1: Is it considered a defect if the first board is not firm after replacing with a new brand of adhesive?
First, follow the preheating and rubber removal process according to the temperature of the new brand, and most of them will recover; Still unable to contact the supplier for parameter review.
Q2: Can the scrapped parts on the first board be recycled?
Paper products are not recommended to be returned to the furnace as the glue has contaminated the paper fibers. It is safer to dispose of them directly.
Hot melt adhesive pelletsThe material is essentiallyComposite solid adhesive with thermoplastic resin as the skeletonThe main body is a base resin (EVA, APAO or PUR prepolymer), combined with thickening resin, wax and antioxidant. Different base resins determine whether it can be used to glue books and magazines, and whether it can be used to seal […]
Thread-sewn perfect bindingStill need to use hot melt adhesive particlesThe only difference is the dosage and location compared to wireless adhesive packaging. The sewing thread connects the book stickers one by one, solving the root problem of loose pages in the text; But the smoothness of the book back, the fit between the spine and […]
First answer: Having more fine powder does not necessarily mean poor quality, but it is worth asking a question Hot melt adhesive granulesA small amount of fine powder at the bottom of the bag is a normal phenomenon. Particles rub against each other during granulation, cutting, conveying, bagging, and long-distance transportation, inevitably producing powder. The […]
The importance of product packaging is twofold: it helps maintain the safety and reliability of the contents and provides consumers with attractive products. The packaging process is one of the most important stages in product manufacturing and distribution. With decades of experience as a packaging hot melt adhesive manufacturer, Sunlife Hot Melt Adhesive is delighted […]