Automatic folding machine hot melt adhesive particle spraying parameter adjustment list: 6 key settings quick check

Why is it difficult to adjust the glue spraying parameters of the automatic folding machine

The automatic flap closer is the core equipment of the express packaging line, and the setting of glue spraying parameters directly affects the quality of the sealed box and the cost of glue used. There are too many parameters that are mutually constrained, and if they cannot be adjusted properly, it will either result in missed coating or glue overflow. This list lists the 6 most critical setting parameters, which can be adjusted according to the table to cover 90% of debugging requirements.

Quick checklist of 6 key parameters

Suggested debugging sequence

• Step oneFirst, set the temperature (starting at 170 ℃), and then adjust other parameters after the temperature stabilizes.
• Second stepAdjust the spraying time and pressure to achieve a glue line width of 2-3mm.
• Step ThreeAdjust the spray adhesive position and delay time to ensure that the adhesive line position is correct and the timing of pressing matches.
• Step FourFine tune the closing pressure to ensure that the folding cover does not pop open after fitting.

Sunlifehot melt adhesive pelletsWhen used in conjunction with an automatic folding machine, the recommended temperature for the Quick Fix series is 168 ℃ and the opening time is 2 seconds. It can be matched with high-speed lines of 15 boxes/minute or more.

Frequently Asked Questions (FAQ)

Q: What is the reason for intermittent glue spraying?

A: Most of them are nozzle blockage or unstable pressure. Clean the nozzle first, and then check if the air source pressure is stable at 2 bar or above.

Q: How to adjust the uneven thickness of the glue line?

A: First check if the glue spraying time is constant, and then check for nozzle wear. The nozzle with severe wear and uneven glue dispensing needs to be replaced.