新闻中心
Select books and magazinesHot melt adhesive granulesI often see a parameter:Open timeIt refers to the time window during which the adhesive can be pressed and bonded onto the spine of a book before losing its stickiness. The window is too short, and if the high-speed line cannot be pressed together in time, the “surface crust” will not stick firmly; If it is too long, the rhythm will slow down and it is easy to draw.

| Gel temperature | Opening hours | performance |
|---|---|---|
| low | Longer but with poor flow | Easy to empty adhesive |
| Recommendation | Normal Window | Adhesive stability |
| relatively high | shorten | Easy to surface crust and false adhesion |
Q: The longer the opening time, the better?
Answer: No, it’s too long and slows down the rhythm, making it easy to draw.
Question: How to choose a suitable window?
Answer: According to the model speed and book type, Sunlife hot melt adhesive process card has recommended values.
Q: Can the opening hours be adjusted on-site?
Answer: It mainly depends on selecting the model, with only minor adjustments to the temperature.
If you can’t understand the parameters, look for Guangzhou Sunlife Trading. Sunlife Hot Melt Adhesive provides a matching plan for opening time according to the model.
Special requirements for teaching aids Teaching aids are books that are frequently read and pulled by children,Hot melt adhesive granulesIt is necessary to ‘keep the page open and the spine intact’. When purchasing, don’t just look at the unit price, make a list of performance and check each item one by one. Procurement Checklist Initial […]
Hot melt adhesive granulesHow to distinguish between good and bad? Buying hot melt adhesive granules should not only be based on price and color, but also on a set of feasible methods. We compared and evaluated the new material particles and miscellaneous materials from five dimensions, and the conclusion is very intuitive. Five step identification […]
Packaging and sealingHot melt adhesive granulesHow long does the curing time usually last? The hot melt adhesive particles used for sealing can be initially cured in only 3-8 seconds from coating to reaching transportable strength, and fully cooled and set in about 20-30 seconds. Compared to water-based adhesive, it takes a few minutes to wait, […]
Direct answer: It is recommended to control the milling depth of conventional wireless adhesive packaging at 1.0-1.5mm, with thin materials up to 0.8mm and thick materials or copperplate paper up to 2.0mm. If the milling is too shallow, the adhesive will only stick to the surface of the crease and will fall off when flipping […]