Hot melt adhesive particle coating solution for sealing the top and bottom of the color box: avoid these 3 pits and double the bonding to improve performance

Three common pits for sealing the heaven and earth lid

The sealing of colored box top and bottom lids (top and bottom lids) is a high-frequency process in the packaging industry, but problems such as lid popping, glue line overflow, and skewed sealing often occur on the production line. Many times nothot melt adhesive pelletsThe quality is not good, it’s just that the glue coating scheme has fallen through.

Pit 1: The glue application position is too close to the edge

Many operators are accustomed to applying glue lines to the outermost edge of the folding cover, thinking that the closer it is to the edge, the stronger the adhesion. In fact, applying glue to the edges can cause the glue to overflow outside the box and cause dirt, and the edge cardboard has low strength and is prone to delamination. Correct method: The distance between the adhesive line and the edge of the folding cover should be reduced by 3-5mm.

Pit 2: Single point glue application instead of line coating

In order to save glue, some schemes only apply 2-3 dots on the folding tongue of the sky and earth cover. The bonding area of dot coating is only 30% of that of line coating, and the lid is easily popped open when the color box is stacked and transported. Correct method: Apply continuously with a glue line width of 2mm, increasing the amount slightly but doubling the bonding area.

Pit three: mismatched opening hours

The time from gluing to closing the lid is determined by the rhythm of the automatic packaging line. If the line rhythm is 2 seconds per box and fast curing adhesive particles with an opening time of only 1.5 seconds are selected, the lid will solidify before the adhesive is closed. Correct approach: Measure the closing time accurately and choose a formula with an opening time 1-2 seconds longer than the closing time.

Sunlife hot melt adhesive granules come in two options: fast curing (with an opening time of 2 seconds) and standard (with an opening time of 5 seconds), which can be matched with different rhythm top and bottom packaging lines.

Frequently Asked Questions (FAQ)

Q: How much glue is suitable for sealing the heaven and earth lid?

A: A sky and earth cover with a single adhesive line length of 30-40cm, with a total of 2-3g of double-sided adhesive coating, can meet the requirements of bonding and transportation.

Q: Is the lid popping open due to too little glue?

A: In most cases, it is a mismatch in the adhesive position or opening time, rather than insufficient adhesive quantity. First investigate the plan and then consider adding glue.