新闻中心
Hot melt adhesive is a type of plastic polymer adhesive. Within a certain temperature range, its physical state will change with the temperature. EVA hot melt adhesive is an environmentally friendly chemical product. Sometimes, when using hot melt adhesive, there may be wire drawing after melting. Affects work efficiency and product aesthetics. So, what is the reason for drawing after melting hot melt adhesive? This is mainly caused by the following factors.

1、 Cohesive strength of hot melt adhesive
The basic cohesion and drawing effect of hot melt adhesive are: high cohesion, obvious drawing phenomenon; On the contrary, if the cohesive strength is low, there will be no wire drawing phenomenon.
2、 Curing time of hot melt adhesive
The curing time of hot melt adhesive is crucial for the occurrence of wire drawing. Generally speaking, hot melt adhesives with short curing times have lower drawing rates because the long filaments formed after curing cannot continue to stretch and are prone to breakage, sometimes even unable to be pulled out.
3、 Rheological properties of hot melt adhesive
The rheological properties of hot melt adhesive have a decisive impact on wire drawing, which is related to the design of the hot melt adhesive formula, the selection of materials in the formula, and the composition.
4、 The influence of machine temperature
If the temperature is too low, the thinness of the glue itself will increase, leading to wire drawing phenomenon.
The above are several reasons for the wire drawing phenomenon of EVA hot melt adhesive. If the above phenomenon occurs during operation, it must be dealt with in a timely manner.
hot melt adhesive pelletsWhat should I do if I get damp? During the rainy season in the south or improper storage in the warehouse, the hot melt adhesive particles may absorb moisture. When damp rubber particles are heated, they will produce a large number of bubbles, overflow, and decrease in adhesion. But not all damp […]
The glue thread is too long and the tail is shaking glue, which is not because the glue is “bad”, but because the opening time, temperature, and glue amount are not properly matched. According to these three inspections, most of the wire drawing problems can be solved.
EVA hot melt adhesive, which is brittle in winter and prone to cracking in summer, belongs to the normal characteristics of thermoplastic materials and is not a product quality issue. It is strongly recommended to prioritize adjusting equipment temperature and production processes, and replace seasonal adhesive when the environment is extreme. At the same time, […]
The aging of hot melt adhesive is mainly manifested in two aspects: appearance and performance. Visually, the color of hot melt adhesive may become dull, and even yellow or brown tones may appear. The texture may become hard and brittle, losing its original flexibility, and the surface may have cracks or fissures. In terms of […]