新闻中心
The automatic line has a fast pace and continuous operation, requiring much higher stability of the glue than manual operation. Confirm the following 7 items one by one, which can reduce three types of high-frequency faults: gun blockage, wire drawing, and explosion.
| project | Automatic line suggestion | Instructions |
|---|---|---|
| Melting viscosity (180 ℃) | 1500–3000 mPa·s | Smooth pumping and good atomization |
| Opening hours | 2-6 seconds | Matching line speed, too fast false adhesion |
| softening point | 90–100℃ | Storage and transportation are not easily softened |
| low-temperature resistance | Select by transportation environment | Northern/cold chain requires antifreeze type |
| ash content | low | Less gun blockage and less machine cleaning |
| thermal stability | good | Long term constant temperature without carbonization |
| odor | low | Workshop and Product Experience |
First, run one or two lines on the new glue for half a day: check if the glue is evenly sprayed and if there is any wire drawing; Take several sealed samples for “drop test” (1.2m free fall 3 times without bursting); Re check in a low-temperature environment for 24 hours. Replace all three items in full.
Q: Can manual sealing glue be directly applied to the automatic line?
Answer: Most likely not. The viscosity and opening time of handmade adhesive do not match the pumping and line speed, which can easily cause gun blockage and false adhesion.
Q: Why is it easier to block guns in the afternoon than in the morning?
Answer: If the glue pot is kept at a constant temperature for a long time, the glue with poor thermal stability will gradually carbonize and accumulate dirt, which will worsen the gun blockage in the afternoon; Choose adhesive with good thermal stability and clean the machine regularly.
Q: Can anyone provide suggestions for automatic line selection?
Answer: Sure. Guangzhou Sunlife TradingSunlife Hot Melt AdhesiveThe packaging and sealing series are provided with models and process parameters based on line speed, glue spraying method (dot/thread/spiral), and temperature resistance environment, and support sample sending for machine testing.
Remember: the automatic line selects glue based on seven factors: viscosity, opening time, softening point, low temperature resistance, ash content, thermal stability, and odor. After passing the small batch test line, the full amount will be determined.
What does the opening time of book and magazine adhesive packaging mean? Select books and magazinesHot melt adhesive granulesI often see a parameter:Open timeIt refers to the time window during which the adhesive can be pressed and bonded onto the spine of a book before losing its stickiness. The window is too short, and if […]
Give me the answer first hot melt adhesiveThe standard English for particles is hot melt adhesive granulesAlso often writing hot melt adhesive pelletsIn the spoken language of foreign customers, it is commonly abbreviated as hot meltBut hot glue stick It refers to the adhesive strip used for the glue gun, not the particles. Do not […]
What is the difference between hot melt adhesive, instant dry adhesive (502), epoxy adhesive (AB adhesive), and pressure-sensitive adhesive? This article compares four types of adhesives by curing method and explains how to choose them according to working conditions.
Direct answer: It’s not the same thing Hot melt adhesive granulesThe testing report often mentions “softening point”, but rarely includes “melting point”. The reason is simple: this type of adhesive is mostly an amorphous polymer blend system, without a clear melting point like crystals, only a gradually softening temperature range. The softening point is an […]
