新闻中心
The core of the book binding strength test is to useSingle page pull-out forceandWhole book folding durabilityWill the two sets of data manuals be missing pages. Conventional practice: Sampling and curing for 24 hours, measuring the pull-out force of a single page inside the book core, and generally requiring wireless adhesive products to be no less than 4; N/cm, And it should be flattened and folded 180 degrees without cracking.

Take one page from the front, middle, and back of the book block, and clamp it along the spine direction; Cm width, using a tensile testing machine to measure approximately 100; Pull out vertically at a constant speed of mm/min, record the maximum force value and convert it to N/cm. Take the average of three points and look at the minimum value at the same time – the weakest page determines the user experience.
Spread the book completely flat to 180 degrees, open and close it 50 times repeatedly, and observe whether there are cracks on the spine and whether the inner pages are loose. Copperplate paper and laminated covers are more likely to expose the problem of insufficient penetration at this stage.
| project | Condition | acceptance criteria |
|---|---|---|
| High-temperature placement | 60 ℃ / 4 h | The spine of the book is not soft or collapsed, and there are no glue stains overflowing |
| Low temperature folding | -5 ℃ / 2 Fold back after h | The adhesive layer is not brittle or cracked |
| stacking | Room temperature pressure 24 h | The spine of the book does not deform or adhere |
Q: What if there is no tensile testing machine?
Answer: Hand tear comparison tests can be conducted, where different batches of the same process are torn in parallel, and significant degradation can be observed. However, this cannot be used as a basis for external quality commitments.
Question: How often do you do it?
Answer: New adhesive batches, new paper, and new machine debugging must be tested; It is recommended to draw one book per shift for daily production, and it must be tested before changing orders.
Question: How long should the data be retained?
Answer: It is recommended to keep the order file until the end of the warranty period, and in case of customer complaints, it can be directly retrieved for comparison.
Using Sunlifehot melt adhesiveFor book and magazine clients, Guangzhou Sunlife Trading can provide reference pull-out force ranges and recommended process windows for this brand on different papers, allowing for benchmark comparability in experiments instead of trial and error every time.
The automatic sealing machine uses hot melt adhesive particles to seal the box, and the process can be summarized as six steps: cleaning and inspection → preheating with adhesive → setting temperature → adjusting the amount of adhesive sprayed → adjusting the sealing test → mass production. Novices can follow the instructions and get started […]
Hot melt adhesive S-295 is one of the Sunlife adhesive models for backing paper, books, and periodicals, and is classified under the same category as S-292/S-296/S-298. Explain clearly where S-295 is used, how to classify models within the same series, and what to pay attention to when using it.
On July 22nd, Chemical & Engineering News (C&EN) of the United States released the “Top 50 Global Chemical Companies 2024”. Eleven Chinese-funded chemical enterprises have made it into the top 50 globally, namely: Sinopec, petrochina, Formosa Plastics, Synthetics under Sinochem Group, Rongsheng Petrochemical, Wanhua Chemical, Hengli Petrochemical, Dongfang Shenghong, Tongkun Holdings, Hengyi Petrochemical, and Xinfengming […]
When pasting hardcover book cover cloth (flower cover cloth on both ends of the spine), it should be selectedHot melt adhesive particles for book and magazine binding with high initial adhesion, short opening time (3-6 seconds), and softening point of 80-95 ℃This process requires a small amount of glue, a narrow area, and quick positioning. […]