新闻中心
The automatic flap closer is the core equipment of the express packaging line, and the setting of glue spraying parameters directly affects the quality of the sealed box and the cost of glue used. There are too many parameters that are mutually constrained, and if they cannot be adjusted properly, it will either result in missed coating or glue overflow. This list lists the 6 most critical setting parameters, which can be adjusted according to the table to cover 90% of debugging requirements.
| parameter | effect | Recommended scope | Adjustment direction |
|---|---|---|---|
| Spray adhesive temperature | Control the fluidity of the adhesive solution | 160-175℃ | If there is a missed coating, the temperature will rise by 5 ℃ |
| Spray adhesive pressure | Control the amount of adhesive produced | 2-4bar | Glue line detailed rules for pressurization |
| Spray time | Single dispensing time | 30-80ms | If the glue is short, there will be a delay |
| Spray adhesive position | Starting point of adhesive line | 3-5mm from the edge | If the glue overflows, it will move inward |
| delay time | Spray adhesive to compression interval | Match opening hours | Degumming shortens the process |
| Combined pressure | Folding cover compression force | 0.3-0.5MPa | Bounce open and apply pressure |
Sunlifehot melt adhesive pelletsWhen used in conjunction with an automatic folding machine, the recommended temperature for the Quick Fix series is 168 ℃ and the opening time is 2 seconds. It can be matched with high-speed lines of 15 boxes/minute or more.
Q: What is the reason for intermittent glue spraying?
A: Most of them are nozzle blockage or unstable pressure. Clean the nozzle first, and then check if the air source pressure is stable at 2 bar or above.
Q: How to adjust the uneven thickness of the glue line?
A: First check if the glue spraying time is constant, and then check for nozzle wear. The nozzle with severe wear and uneven glue dispensing needs to be replaced.
< p > < strong > < a href = "https://www.sunlife888.com/en/" > < / a > using hot-melt adhesive method. Industrial hot melt adhesives are used in applications formulated for specific purposes in each industry. There are all kinds of dispensing machines, glue sticks and hot melt glue particles, all of which are designed for […]
Answer directly UnopenedHot melt adhesive granulesIt can usually be stored for 12-24 months in a cool and dry place; Once opened, it is recommended to use it within 3-6 months. Whether it is sealed or not directly determines whether the rubber particles will absorb moisture, clump, and decrease in performance. Sealed storage vs open storage […]
General conclusion:Standard spot models can be shipped within 1-3 days, non-standard customized or color matching models within 7-15 days, and export orders with third-party testing reports within 15-25 days.But this is just an ideal state, what really determines when you can turn on is the following 8 factors. By checking them one by one, the […]
Hot melt adhesive particles for high-speed sealing of cardboard boxes are not necessarily better with higher tensile strength. The sealing fastness also depends on the wetting of the corrugated paper by the adhesive particles, the cooling speed of the adhesive dots, the spraying rhythm, and the pulling direction during transportation. Sunlife hot melt adhesive recommends […]
