新闻中心
EVA hot melt adhesive, which is brittle in winter and prone to cracking in summer, belongs to the normal characteristics of thermoplastic materials and is not a product quality issue. It is strongly recommended to prioritize adjusting equipment temperature and production processes, and replace seasonal adhesive when the environment is extreme. At the same time, it is strictly prohibited to mix different types of adhesive, which can completely solve this problem..

EVA hot melt adhesive belongs to thermoplastic materials, and the temperature will directly change the colloidal state.
Prioritize debugging the equipment, and then replace the glue. Step by step operation can improve the situation.
Summer glue opening is often related to the production process and glue type, and should be investigated and handled in order.
Many factories mix leftover winter glue with summer glue, which is a typical mistake.
Q: Is EVA hot melt adhesive brittle in winter and prone to cracking in summer due to poor adhesive quality?
A: No, it’s not. It is a normal characteristic for thermoplastic materials to be affected by temperature, which can be solved by adjusting equipment and replacing specialized adhesives.
Q: Can I use winter hot melt adhesive in summer?
A: No, it is highly likely to cause problems such as softening, glue opening, wire drawing, and equipment blockage.
Q: Can adjusting the temperature without changing the glue cope with the temperature difference in all seasons?
A: Feasible when the temperature difference is small; In high temperature exposure, severe cold and low temperature scenarios, it is necessary to replace the seasonal adhesive.
Using hot melt adhesive particles on the same material surface will provide better quality assurance, as hot melt adhesive is always sprayed on the material surface in a molten state – this helps to generate thermal reactions and increases adhesion compared to adhesives, without using heat during the bonding process. Stable quality provides good adhesion […]
Direct answer: A new sample must be made changeHot melt adhesive granulesSuppliers, even if they claim that the parameters are exactly the same and can be directly replaced, must still make new samples on their own equipment and actual substrates. The reason is that two adhesives with the same nominal softening point of 85 ℃ […]
It’s not that difficult to change the glue for the glue installation machine in the graphic store Many graphic and text store owners are afraid of changinghot melt adhesive pellets——Afraid of blocking rubber hoses, afraid of temperature switching problems, and afraid of wasting glue. In fact, as long as you follow the steps, it can […]
Direct answer: The width of the side glue for regular 16 open books and magazines is 4-6mm, for 32 open books it is 3-5mm, and for large 16 open or thick books (book spine exceeding 20mm) it can be relaxed to 6-8mm. The width of the side glue should be “able to effectively grasp the […]