新闻中心
Choose hot melt adhesive granules and focus on 7 key parameters: softening point, melt viscosity, opening time, curing time, initial adhesion, temperature resistance range, color and appearance. This article compiles the meanings, common ranges, and selection points of each parameter into a table, which can be directly compared and used by procurement and technology.
| parameter | Common intervals | Key selection points |
|---|---|---|
| softening point | 75-110℃ | Determine heat resistance, it is recommended for summer warehousing logistics to be above 85 ℃ |
| Melt viscosity | 1000-8000mPa·s(180℃) | Choose low viscosity and good flow for high-speed lines, and high viscosity for thick adhesive layers |
| Opening hours | 5-60 seconds | Match the rhythm of the equipment, the glue binding line should be short and the mounting should be long |
| curing time | 2-15 seconds | Determine the length of the pressing station, fast line with fast curing |
| Initial tack | Measured by peel strength | Sealing and pasting boxes require high initial adhesion and anti rebound |
| Temperature resistance range | -From 20 ℃ to 70 ℃ | Select based on extreme temperature during storage and transportation |
| Color Appearance | Water white/light yellow/yellow | Books and periodicals should be selected with white water that does not penetrate the bottom, and light yellow can be used for sealing |
Q: Where can I get the parameter table?
Regular manufacturers have technical parameter tables for each model, and Sunlife hot melt adhesive can provide TDS with samples, including recommended construction temperature and all key parameters.
Q: How to choose between two models with similar parameters?
Prioritize choosing the one with better actual testing results compared to your own materials. Guangzhou Sunlife Trading supports sending materials for testing, speaking with data.
Stick this table next to the procurement station and check the parameters item by item. The probability of selecting the wrong adhesive particles will be significantly reduced.
Hot melt adhesive granulesHow to read the test report? Legitimate hot melt adhesive particles should come with a testing report when leaving the factory. Newcomers are often discouraged by a bunch of indicators, but in fact, by grasping a few key items, one can judge whether it is good or bad. Below is a comparison […]
Why can hot melt adhesive stick to things? This article discusses the four step physical bonding principle of heat clearing adhesive: “solid state → melting → infiltration → cooling and solidification”, as well as the effects of temperature, opening time, and penetration on bonding strength.
Why is thermal stability importanthot melt adhesive pelletsThe core indicators? Heating hot melt adhesive particles in a glue pot for a long time will accelerate the decomposition of products with poor thermal stability, resulting in decreased adhesion, darker color, and increased carbides. Understanding thermal stability indicators is a fundamental skill in selection. Three core indicators […]
Let’s first clarify what REACH actually covers REACH is the chemical regulation of the European Union, which regulates “substances” rather than “whether a product is good or not”.Hot melt adhesive granulesAs a mixture exported to the EU, there are two core obligations: first, each substance in the formula must be registered or exempted from compliance […]
