What should I do if the sealed hot melt adhesive particles block the rubber hose? Comparison of Two Solutions

Sealed boxHot melt adhesive granulesWhat should I do if I block the rubber hose?

The sealing line is most afraid of rubber hose blockage: the dispensing speed may fluctuate, and even flow may be interrupted, resulting in poor sealing of the box. There are two common reasons for pipe blockage – incorrect glue temperature and unclean glue material. Compare the two mainstream solutions below.

Solution 1: Adjusting the process (low-cost)

• Check the recommended coating temperature, if it is too low, raise it to the median of the range.
• Clean the carbonized residue, replace the filter screen, and ensure smooth flow.
• Control the material level of the glue tank to avoid empty burning and coking.

Solution 2: Replace the adapted particles (cure)

• Choose sealed particles with good thermal stability and low impurities to reduce coking.
• Use viscosity models that match the model, without forcing temperature.

Comparison of Two Solutions

Frequently Asked Questions (FAQ)

Q: Is the blockage caused by the glue or the machine?
Answer: Check the temperature and cleanliness first, and then consider changing materials frequently.

Q: Will Sunlife particles clog the tube?
Answer: Less impurities, good thermal stability, and basically no blockage when used according to the process card.

Question: How to prevent it?
Answer: Temperature control+frequent cleaning of filter screen+stable brand, three piece set.

Seal the box with old blockages, find Guangzhou Sunlife Trading to exchange Sunlife hot melt adhesive sealing particles and obtain the process card.