新闻中心
Hot melt adhesive is a type of plastic polymer adhesive. Within a certain temperature range, its physical state will change with the temperature. EVA hot melt adhesive is an environmentally friendly chemical product. During use, sometimes hot melt adhesive may be pulled out after melting. What is the reason for drawing hot melt adhesive after melting, which affects work efficiency and product aesthetics? This is mainly caused by the following factors.

1、 Cohesive strength of hot melt adhesive
The basic cohesion and drawing effect of hot melt adhesive are: high cohesion, obvious drawing phenomenon; On the contrary, if the cohesive strength is low, there will be no wire drawing phenomenon.
2、 Curing time of hot melt adhesive
The curing time of hot melt adhesive is very important for the occurrence of wire drawing. Generally speaking, hot melt adhesives with short curing times have a lower chance of drawing because the fine threads formed after curing cannot continue to elongate, making them prone to breakage and sometimes not even drawing out.
3、 Rheological properties of molten hot melt adhesive
The rheological properties of molten hot melt adhesive have a decisive impact on wire drawing, which is related to the design of the hot melt adhesive formula, the selection of materials in the formula, and the composition.
4、 The influence of machine temperature
If the temperature is too low, the thinness of the glue itself will increase, leading to wire drawing phenomenon.
The above are several reasons for the drawing phenomenon of EVA hot melt adhesive. If the above phenomenon occurs during operation, it must be dealt with in a timely manner.
Direct answer:Hot melt adhesive pelletsThe cost of raw materials generally accounts for 65% to 80% of the factory price. Taking EVA type hot melt adhesive granules commonly used in book binding as an example, in 2026, the raw material cost will be approximately 9000-13000 yuan per ton, while the finished product price will mostly fall […]
Direct answer: The most secure arrangement for sealing and gluing points is to leave 20-30mm at both ends, evenly distribute in the middle, and cover a total length of about 60% -70% of the sealing length. The common three-point, five point, and strip continuous methods have their own applicable scenarios. Choosing the wrong arrangement not […]
EVA polymer hot melt adhesive is solvent-free, anhydrous, and 100% solid meltable. Main ingredients: resin, adhesive, viscosity modifier, antioxidant, etc. Fischer Tropsch wax in productionEVA hot melt adhesiveAs a viscosity modifier, it mainly reduces the viscosity of polymers and increases fluidity. EVA hot melt adhesiveTypes of viscosity modifiers: Commonly used viscosity modifiers include paraffin wax, […]
What is wireless adhesive binding? Wireless adhesive binding refers to a binding method that uses adhesive to fix the pages of printed materials on the spine of a book. Unlike traditional wired binding, wireless adhesive binding does not use wire or thread, but instead uses glue to bond the book core. The book core processed […]