新闻中心
PET (polyethylene terephthalate) plastic film has low surface energy and high crystallinity, and is widely recognized as a difficult to stick material. Ordinary EVAhot melt adhesive pelletsThe problem of initially sticking PET but suddenly decreasing peel strength after cooling is often encountered, and the fundamental reason is that the adhesive cannot effectively infiltrate the surface of PET.
The key to making the hot melt adhesive particles stick firmly to the PET film is not about “how thick to apply”, but about “choosing the right model”. There is a modified formula specifically developed for low surface energy materials in Sunlife hot melt adhesive granules, which enhances the affinity for PET surface by introducing polar groups. After cooling, the peel strength can reach over 3N/cm.
The technical team of Guangzhou Sunlife Trading can recommend corresponding models based on customers’ specific PET film types (transparent/aluminum plated/printed surface).
Q: How long does it take for the hot melt adhesive particles to peel off after sticking PET?
A: Ordinary rubber particles usually have edge warping within 24-48 hours; After selecting the right modified formula, it can maintain adhesion for a long time without detachment at room temperature.
Q: Can we compensate for the weak adhesion by increasing the amount of glue applied?
A: Not recommended. Excessive thickness of the adhesive layer can increase internal stress and accelerate delamination. The correct approach is to change the formula rather than the amount of adhesive stacked.
Q: Is aluminum coated PET film harder to stick than transparent PET?
A: Yes, it is. The aluminum plating layer blocks the penetration of the adhesive solution, so it is necessary to choose modified adhesive particles with stronger permeability or apply a primer treatment on the aluminum plating surface.
In order to improve the quality of board edge sealing in the furniture industry, more and more manufacturers are upgrading edge sealing from EVA technology to PUR technology. PUR hot melt adhesive undoubtedly has better strength and heat and water resistance than EVA, and its final bonding performance is surplus for indoor furniture. Therefore, […]
Analysis of aging reasons of EVA hot melt adhesive during use? Many customers encounter a decrease in viscosity and insufficient bonding strength of EVA hot melt adhesive after prolonged use. It is usually considered that the product quality is poor. However, this is not the case. This phenomenon is likely caused by the aging of […]
Direct answer: When printing and packaging companies conduct environmental impact assessments or apply for pollutant discharge permits, it involveshot melt adhesiveThere are usually five types of particle information – product MSDS (Safety Data Sheet), component and solid content description, VOCs and non methane total hydrocarbons generation basis, annual dosage and process addition method description, supplier […]
Uneven glue application, first check the glue roller The glue roller on the book binding line is used for coatinghot melt adhesive pelletsThe core components. Once the roller surface is worn, the adhesive layer will experience uneven thickness, breakage, overflow, and other problems, directly affecting the bonding strength and appearance quality of the spine. Typical […]
