新闻中心
EVA hot melt adhesive is different from regular cold melt adhesive. According to its characteristics, the following points must be mastered and noted during use:
When using EVA hot melt adhesive, do not heat it directly with an open flame. Be sure to heat with isolation oil (the boiling point of water should reach 100 ℃) or use a sealed electric heating plate. Before using solid EVA hot melt adhesive, it must be preheated with a preheating device and then released into the working glue box of the adhesive. The preheating time is generally around 2 hours. When using glue, do not directly mix solid glue blocks (i.e. glue that has not been preheated) into the glue box to prevent Poor fluidity of glue or applying partially melted glue on the back of the book, resulting in uneven application of glue. The amount of glue in the preheated glue pot should be controlled properly. If too much is used, the glue will melt one by one, causing deterioration and aging, reducing viscosity, and affecting adhesion. The entire bonding process must be completed within the opening time of the hot melt adhesive. If the machine is stopped due to a malfunction, the books in the bookshelf must be removed in a timely manner, and the book core must not stay above the glue wheel. When repairing wireless adhesive binding equipment for a long time, the pre coating glue and working glue pot should be turned off to prevent glue aging. The temperature of the molten colloid should be strictly controlled within the range of use. Direct answer:Hot melt adhesive granulesAfter absorbing water, the machine may experience bubbling of the melt adhesive, white spots on the adhesive layer, and decreased adhesion. In severe cases, the entire pot of adhesive may be scrapped Hot melt adhesive particles are hydrophobic but porous particles that will slowly absorb moisture after prolonged exposure after opening. […]
Hot melt adhesive granulesIs it suitable for sticking PP plastic? PP (polypropylene) plastic has extremely low surface energy and is difficult to wet. Ordinary EVA hot melt adhesive particles stick directly, which is basically a “false adhesion” and can be easily peeled off. This is the most common pitfall: thinking that hot melt adhesive is […]
Direct answer: Generally, high-strength spine glue is not used for bonding the inner pages of coil books. Instead, low-temperature or medium temperature EVA with shorter opening time (2-4 seconds), high initial adhesion, and good flexibility should be selected Hot melt adhesive pelletsThe softening point is between 80-90 ℃. Because the adhesive of the coil book […]
How to avoid equipment failure caused by carbonization of EVA hot melt adhesive? The carbonization of hot melt adhesive in the hot melt tank is left unattended, which can damage your equipment, have a negative impact on your factory’s productivity, and cause unnecessary downtime. Follow these simple tips to reduce hot melt adhesive carbonization and […]