新闻中心
There is no unified “melting point” for hot melt adhesive particles, which are more commonly used in the industrysoftening pointandRecommended temperature for useTo describe. The softening point of common EVA hot melt adhesive particles is about 70 ℃ -110 ℃, while the actual coating (gluing) temperature is usually between 150 ℃ -190 ℃ – much higher than the softening point, because it needs to fully melt and flow to penetrate the paper fibers.

| Type | softening point | Recommended coating temperature |
|---|---|---|
| Universal EVA | About 80-95 ℃ | 160–170℃ |
| High viscosity EVA | About 90-105 ℃ | 170–180℃ |
| Low temperature fast solidification | About 70-85 ℃ | 150–160℃ |
Q: Is a lower melting point better for use?
Answer: No, low melting point is prone to clumping in summer, it depends on the stability of the formula.
Q: Can particles be selected by melting point?
Answer: It depends on whether the recommended coating temperature matches the model. Sunlife hot melt adhesive is provided with a process card for each batch.
Q: How to remedy the temperature setting error?
Answer: Immediately call back to the recommended range, clean the carbonized rubber, and avoid pipe blockage.
We need an accurate temperature window to obtain the process parameters for the corresponding model of Sunlife hot melt adhesive from Guangzhou Sunlife Trading.
When hot melt adhesive melts, the odor suddenly increases, which is mostly due to temperature, carbonization, or mixing problems. This article explains the sources and methods of odor reduction, and provides recommendations for selecting low odor products.
Adhesive failure Adhesive joints exhibit incomplete continuity in construction, which often makes them the focus of stress concentration. Under the combined action of external forces and environmental stress, joints are prone to damage. The failure strength of a joint, which refers to the maximum load that a unit of bonding area or length can withstand, […]
What hot melt adhesive is used for book binding? Nowadays, EVA type hot melt adhesive is commonly used to stick the side of books, and PUR type hot melt adhesive is also available, but the cost of using PUR type hot melt adhesive will be slightly higher. The process of gluing the spine is as […]
Petroleum resin is a thermoplastic resin produced by pre-treatment, polymerization, distillation, and other processes of C5 and C9 fractions produced as by-products of petroleum cracking. It is not a high polymer, but an oligomer with a molecular weight between 300-3000. C5 petroleum resin ① Name and characteristics Chinese alias: C5 resin; Fatty hydrocarbon resin. English […]