新闻中心
Why do hot melt adhesive particles emit a lot of smoke during the heating process? When using hot melt adhesive, its viscosity can only be affected by heating. The hot melt adhesive equipment used in industry cannot do without a heating system. Sometimes, there may be a large amount of abnormal smoking during the heating process. Why can operators ask? Although we know this is a bad phenomenon, we don’t know how to solve it. In fact, this issue is summarized by the industry. There are roughly three types of problems:
1,Factors influencing human behavior
A typical hot melt glue machine has a glue box that is heated by a heating plate. When the amount of hot melt adhesive in the box is not less than 1/3, it needs to be added. If the operator does not heat the glue, the amount of glue inside the box will gradually decrease below the surface of the heating plate. In this way, during the continuous heating process, the heating plate will come into contact with the air, and the smoke emitted from the glue box will cause severe carbonization of the glue, affecting its use. Therefore, operators should pay attention to the amount of glue in the box during equipment operation and add new glue to keep the glue surface submerged in the heating plate;
Another human factor is that the temperature applied during the application of the hot melt adhesive particles is too high. It is believed that increasing the temperature can accelerate the melting of the adhesive and improve its performance. In fact, doing so would backfire because hot melt adhesive has a reasonable temperature range during use, and overheating can easily lead to carbonization and smoking. Therefore, when setting the device temperature, it is necessary to follow the parameter range of the hot melt adhesive manufacturer.
2. Heating system control equipment loses control
When using hot melt adhesive granules, the equipment has already reached the working temperature specified by the hot melt adhesive manufacturer, but there is still smoke present. This may be due to a mismatch between the heating temperature of the device and the settings. Some devices are equipped with temperature sensors to achieve a constant temperature effect. When the device malfunctions or malfunctions, it will continue to generate heat and smoke when the temperature passes. This phenomenon requires major repairs and replacement of parts for the car here.
3、 The quality of hot melt adhesive is unstable
If the selected hot melt adhesive has poor thermal stability, it is prone to carbonization and decomposition at normal operating temperatures. In this situation, it is necessary to contact the manufacturer in a timely manner and replace the natural quality of the hot melt adhesive.
Many masters feel that “keeping the glue pot on is the most electricity consuming”, so they frequently switch it on and off. actuallyRepeated cold start consumes more power and damages equipment than insulationBelow are three common misconceptions. Misconception 1: Keeping it on=burning at full power all the time The glue pot isThermostat ControlAfter reaching the […]
Based on thermoplastic polymers, the properties of hot melt adhesives allow them to melt at high temperatures and then return to a solid state when the ambient temperature is reached. Hot melt adhesive has a wide range of applications, and its formula has obvious advantages over traditional adhesives. They can be combined with almost anything, […]
Under standardized storage, the shelf life of EVA hot melt adhesive granules is usually 12-24 months; Polyolefin and other systems can last longer. But ‘shelf life’ does not mean ‘just leave it at will’, the environment determines the actual usable time. Key factors affecting shelf life Reference for shelf life of different systems system Reference […]
The common quality problems of wireless binding hot melt adhesive mainly include page dropping, uneven back, broken book core, bubbles, and perforation at both ends of the book. They often appear on single or multiple banks, mainly due to the following reasons: 1、 Analysis of Page Dropping Reasons (1) The milling groove is too shallow […]
